Mount the Brackets
Before you begin
Check your ‘Measure’ sheet to determine the configuration of the blind.
You need to determine what type of surface you are mounting your bracket to. Predrill using the brackets as a guide. Ensure you use appropriate plugs and masonary tools if mounting into brick or stone. It’s best to install brackets on studs if possible.
Timber
We recommend predrilling holes and use 25mm button head screws
Plaster
We recommend a wall anchor.
Stone, Concrete, Brick, Tile
Use a masonry drill with appropriate screws, anchors and plugs
Install - face fit
Screw clip into blacket, ensuring clips face the same direction.
Push lip of the track in and then rotate the other into place.
Simply feed slat into runners lean on a slight angle and the slat will sit inside the hook. And then hang the wand if ordered.
Install - recess fit
Screw clip into the recess, ensuring clips face the same direction.
Push lip of the track in and then rotate the other into place.
Simply feed slat into runners lean on a slight angle and the slat will sit inside the hook. And then hang the wand if ordered.
Install the safety clip
A child safety clip must be installed if the chain sits lower than 1.6 metres from the floor.
We here at Blinds On Demand take the safety of our kids very seriously.
Fit the chain into the loop of the clip. Pull the clip down until it is as tight as possible without placing tension on the chain. Screw into place.
